Any of these conditions threaten the reliability of the equipment being inspected.
Ultrasonic electrical inspection.
For comparison an ultrasonic sound recording was taken of the sister unit which was under similar operating conditions.
To help us identify any problem issues before we begin we use ultrasonic probes carrying out energised testing our trained technicians use ultrasonic probes as safety devices before opening any electrical enclosure to identify any unusual electrical noise such as mechanical chatter arcing and tracking within your equipment.
At any voltage thermal anomalies and sources of ultrasound such as tracking and arcing can occur.
Gettle s ultrasonic testing specialists provide full service testing solutions that can identify electrical system issues before they lead to.
Ultrasonic testing ut is a family of non destructive testing techniques based on the propagation of ultrasonic waves in the object or material tested.
Ultrasound and infrared technologies are a perfect match when conducting inspections of electrical equipment.
The inspection s findings an ultrasound examination of one of the units revealed a suspect sonic signature in the b phase coil.
Ultrasonic testing ultrasonic testing uses ultrasound technology to detect high frequency sounds related to electrical discharges resulting from the ionization of arcing tracking and corona.
In most common ut applications very short ultrasonic pulse waves with center frequencies ranging from 0 1 15 mhz and occasionally up to 50 mhz are transmitted into materials to detect internal flaws or to characterize materials.
An ultraprobe detects high frequency sounds produced by these emissions and translates them via heterodyning down into the audible ranges.
How ultrasonic electrical inspection works partial discharge tracking arcing and corona all produce ionization which disturbs the surrounding air molecules.
Ultrasonic inspection can be used for flaw detection evaluation dimensional measurements material characterization and more.
To illustrate the general inspection principle a typical pulse echo inspection configuration as illustrated below.
Ultrasonic testing ut is a non destructive testing techniques based on the propagation of ultrasonic waves in the object or material tested.
When performing an ultrasonic electrical inspection the ultrasound technician may select 40 khz to detect an electrical anomaly sound waves moving through the air.
In most common ut applications very short ultrasonic pulse waves with center frequencies ranging from 0 1 15 mhz and occasionally up to 50 mhz are transmitted into materials to detect internal flaws or to characterize materials.
Corona can also occur at 1000 volts and greater.